Applying asphalt paving is a fairly straightforward process. If you have the right equipment and a little knowledge of asphalt, the job can be done quickly and easily in Kissimmee Florida. But if you’re working with asphalt that’s not quite up to your standards, it’s still possible to do a lot of the work yourself.

Start by making sure your driveway and sidewalks are as clean as possible. Dirt, leaves, and dust will accumulate at these locations over time, so scrubbing and mopping regularly will go a long way towards keeping them looking nice. This is also an excellent time to vacuum and sweep your home. A clean surface will help make your asphalt work go much smoother.

Before you start working on the surface, make sure to remove all debris from under your vehicles. You can use a leaf blower or the backhoe attachment on your tractor to get the job done. If the surface looks dry enough, you can apply a coat of asphalt paint, though most experts recommend applying the first layer with a non-abrasive material, such as rubber cement.

Next, make sure to check your foundation’s slope and grade before you get started. Too steep or too uneven a slope means the asphalt won’t be as uniform. Too flat is better because it’ll provide better drainage and allow for easier backing and leveling. Your support beams should also be checked for proper alignment, as well as any cracks or voids.

In order to use a sealer, you will need to use a rubber cement (also known as rubber cement) that’s been specially formulated for asphalt pavements. Using a commercially prepared sealer will get the job done, but it won’t be as strong or as durable as one that’s made specifically for this purpose. In addition, when doing any of the steps above, make sure to lubricate any exposed steel surfaces with a good grease product, which will help the job go smoothly.

Now that you’ve done the necessary preparation for your paving project, begin to lay the first layer of asphalt. The thickness of the foundation will determine how long the layer takes to finish. The reason for this is that the thicker the layer, the more likely the asphalt will be to crack.

Whether you’re using old asphalt or a newer product, lay the new asphalt as soon as possible after you finish removing the old. Many people tend to skip this step, thinking that they’ll continue to use the same asphalt until they see cracks. But the layers of asphalt take a very long time to cure, and if you wait too long, the asphalt will be quite difficult to install in the future.

Then, lay down a base that will contain the next layer of loose gravel. If you’ve installed a retaining wall, you can use a material called “stump filler” to add some extra support. But most of the time, you’ll want to follow the instructions for a standard curb cut. This is when you take a standard driveway and turn it into a decorative boulevard, with an elevated center.

To complete the process, level off the first row by matching it up with the adjacent rows. If you’ve done it correctly, you should end up with a driveway that runs perpendicular to the curb, and is even in the middle. In fact, if you turn the driveway into an elevated road by building straight and level curbs, you should end up with a drive that is about twice as wide as the drive itself.

Finally, apply a finishing sealant and finish your driveway off with a roofing liner to prevent water damage. All of this can be done in just a few hours, without the help of a professional. And all of the work that needs to be done, once the paving has been completed, can easily be done by an average person. An asphalt paving project can be easily done by a homeowner who knows what they’re doing. The process is pretty simple, requiring very little special equipment, and even less time than you might think. All you need is a little bit of common sense and some elbow grease, and you’re well on your way to making your driveway look great.

So, if you’re in the market for your own asphalt paving, don’t worry. It’s a fairly easy process, and it can be done in a weekend.